1. first using feed crusher. Because the mould pinch roller of feed pellet mill is mostly a heat treatment, after workstage as planning, drilling, milling, quenching, there are many burr inner bore or surface, influence the effect and the production, so a new feed pellet mill(or replacement of the complete sets) before using, must be reasonable ground fully.
2.the grass meal and moisture content configuration. To ensure the quality and yield, grass meal content of flat die pellet making machine use had better not more than 95%, ring die pellet mill use not more than 65%, because the higher the toppings content, the lower the output will be, and the input-output ratio will disorders, the production efficiency will be at a discount greatly.If joining grass meal, must add appropriate moisture (about 2-8%) to adjust, then the material evenly and fully quickly squeezing out granular feed, the dust content of feed could be and reduced
Material transport and storage, some of you may already be familiar with the fact that ground hay does not flow and has serious bridging problems. We’ve tackled this issue by applying constant mechanical agitation using augers. Augers transport raw material between all of the components on our trailer. We spent months building an effective mixing bin that would act as a buffer between the hammer and pellet mills. I believe that it was our fifth iteration that finally worked. This buffer zone compensates for the variable output of the hammer mill and is key in ensuring a constant feed rate to the pellet mill.
No comments:
Post a Comment